Board
Search
Member List
Calendar
Red Dot Arms
Help
01-04-2015, 09:14 PM
OK well that is pretty normal. Those bushing charts are always plus or minus a hole so to speak, so you always want to determine the right bushing before putting shot in so you can just turn the press upside down and dump the powder to change it. If there is shot in the press, then you have to dip the shot out and fool around with it in order to pull the charge bar and change the bushing. I wish they made that press in .410. I hate to buy a Mec 600 to load them but its about the only economical way to do it...